The DFS T-Anchor has a gravity activated toggle head for use in hollow walls and ceilings. Can be used in concrete, steel and wood.
T-ANCHORS
Item Number
Diameter x Total Length
Grip Range
Drill Size
Box Qty.
14134TS
1/4" x 1 3/4"
1"
5/16
100
14212TS
1/4" x 2 1/2"
1" - 1 3/4"
5/16
100
14314TS
1/4" x 3 1/4"
1" - 2 1/2 "
5/16
100
56212TS
5/16" x 2 1/2"
7/8" - 1 1/2"
5/16
100
56314TS
5/16" x 3 1/4"
1 1/4" - 2 1/4"
5/16
100
56334TS
5/16" x 3 3/4"
1 7/8" - 2 3/4"
5/16
100
38314TS
3/8" x 3 1/4"
1" - 2"
3/8
50
38334TS
3/8" x 3 3/4"
1 7/8" - 2 1/2"
3/8
50
38400TS
3/8" x 4"
2" - 2 3/4"
3/8
50
38412TS
3/8" x 4 1/2"
2 1/8" - 3 1/8"
3/8
50
Drill hole proper diameter
Insert Anchor with nut and
washer attached.
Gravity turns retaining bar.
Tighten nut until anchor is set
What advantages are there?
A 5/16" toggle bolt requires a 7/8" hole. The T-Anchor with a 5/16" hole. Same drill bit diameter as anchor diameter.
T-Anchors can be used in concrete block, wood, steel or and any hollow space application.
• Smaller hole requirements than toggle bolts
• May be used in hollow block walls and ceilings
• One size hole to drill... No realigning of holes is necessary
• Zinc & dischromate plated for corrosion resistance
• Nuts & washers included
• Available in open stock boxes or bulk
• Electrical Boxes
• Shelving Brackets
• Cable TV Units
• Any Hollow Wall or Ceiling Application!
TEST PERFORMANCE DATA
Diameter
Pull Out
Shear
1/4" (all lengths)
700 lbs.
1500 lbs.
5/16" (all lengths)
900 lbs.
12300 lbs.
3/8" (all lengths)
1000 lbs.
3000 lbs.
T-Anchors comply with these industry standards:
Meets or exceeds G.S.A. Standards G.S.A. FF-B-588C
Meets load factors in compliance with A.N.S.I. A58.1
Meets plating standards in compliance with A.S.T.M. B-633
Products tested in accordance with A.S.T.M. E-488.88
A safety factor of 4:1, or 25% of ultimate, should be used. Critical applications (vibratory loads, overhead installations, etc.) may require a safety factor of as much as 10:1 or more.
